![]() ![]() It's weird because the bullet points with bold text is exactly what the CraftEdge support told me to do earlier and I still had no such luck until I re-installed the latest USB driver just now. Turns out, the solution for my situation was NOT the keyspan adapter, but an updated USB driver. I went in circles jumping from various sets of instructions for setting up the MH series with a Mac, installing and uninstalling drivers for the last two weeks trying to troubleshoot. Hope this helps anyone else with a USCutter MH365 MK2 and a Mac. So I've noticed the view count for the original post has been steadily increasing, which leads me to believe others have also encountered a similar problem. In this window it says the following block message: It then shows the "Cutting." queue window grayed out with the word "Initializing." for a couple of seconds before an error window titled "Cutting Machine Not Found" pops up. With everything plugged in and turned on, I add some text to the work area in SCAL, select it, choose my cutter, and send it to cut. The USB connection is seen by my computer as evidenced when I look it up in my computer's Utility/System Information under Hardware > USB as "USB-Serial Controller D" in the USB Device Tree below USB High-Speed Bus > Hub. I also installed the FTDI USB driver via the Help menu in SCAL.Īnd prior to attempting to run a test using SCAL I rebooted my computer. I downloaded and installed the driver as directed and provided at, and changed the Baud Rate settings on the cutter to 4800. I'm working with a MacBook Pro OS X version 10.7 with Intel processor and have the cutter hooked up using a keyspan USB to serial adapter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |